Electrical Circuits for Water Ions Sensing
- ,
- Omar Awayssa(corresponding author),
- Mahmoud Al Ahmad(corresponding author),
- ,
- ,
- United Arab Emirates University
Research Output:
Contribution to journal
Article
Research
Peer-reviewAbstract
<p>Reliable sensing of ionic composition in water is essential for environmental monitoring and water quality assessment, yet conventional analytical methods often require laboratory instrumentation, chemical reagents, and extensive sample preparation. Here, we show that electrochemical impedance spectroscopy (EIS) can provide a rapid, nondestructive route for identifying ionic signatures in seawater, groundwater, bottled water, and systematically prepared single-ion and mixed-ion solutions containing Na+, K<sup>+</sup>, Ca<sup>+2</sup>, and Mg<sup>+2</sup> over environmentally relevant concentration ranges. Impedance spectra measured from 1 Hz to 1 MHz at 4 °C and 23 °C reveal reproducible composition- and temperature-dependent behavior: increasing ionic content lowers impedance magnitude, strengthens the capacitive response at intermediate frequencies (100 Hz–100 kHz), and induces high-frequency inductive features in highly conductive samples. To interpret these responses, we developed a modified equivalent-circuit model comprising resistive, capacitive, and inductive elements, which accurately reproduces the measured spectra across a wide frequency range. Inclusion of the inductive term was necessary to capture the positive high-frequency phase shift observed in saline samples. The extracted circuit parameters were then used as compact descriptors for ion estimation and water classification. A category-guided framework was implemented in which unknown samples were compared against seawater, groundwater, and bottled-water reference models, with the minimum-distance model selected for final prediction of sodium, potassium, calcium, and magnesium concentrations. Representative case studies correctly identified SW1, GW2, and Fiji samples, yielding ion estimates consistent with the measured values. Principal component analysis further showed clear separation among the three water classes, with the first two components accounting for 84.34% of the total variance. These results establish impedance-derived circuit fingerprints as a physically interpretable alternative to conventional laboratory assays for rapid water-quality assessment and ionic composition analysis.</p>
Research Output Information
Output type
Research Output:
Contribution to journal
Article
Research
Peer-reviewOriginal language
EnglishPages from-to (Number of pages)
Pages 20627-20640 (14 pages)Journal (Volume, Issue Number)
IEEE Sensors Journal (Volume 26, Issue 14)Publication milestones
- Published - 2026
Publication status
Published - 2026
ISSN
1530-437XPublication IDs
- Scopus: 105040956784
Documents and links
Publication metrics
PlumX, opens in new tab
Captures
2
Sustainable Development Goals
- SDG 6 Clean Water and Sanitation
